Hindmechanisch Precision Tools Private Limited

Hindmechanisch's BT50 Morse Taper holder are used to hold Tang type shanks 

BT50 morse taper Is mainly used to hold Tang Type Drills and Arbors  

• Better shank taper - accurate, rigid toolholder-to-spindle mount
• Fully ground flange and V-groove, easy on the tool changers for less spindle and changer maintenance
• Made from alloy steel hardened to 54 – 56rc
• Balanced at G6.3 at 15,000 rpms by hammer machining machine.
• Concentricity is less than .005 micron upto 100 Length and 0.012 upto 200 Length
• All holders are black oxide and cotted with rust prevent.
• Rear thread for pull stud is M24 X 1.75.

Hindmechanisch's BT40 Morse Taper holder are used to hold Tang type shanks 

BT40 morse taper Is mainly used to hold Tang Type Drills and Arbors  

• Better shank taper - accurate, rigid toolholder-to-spindle mount
• Fully ground flange and V-groove, easy on the tool changers for less spindle and changer maintenance
• Made from alloy steel hardened to 54 – 56rc
• Balanced at G6.3 at 15,000 rpms by hammer machining machine.
• Concentricity is less than .005 micron upto 100 Length and 0.012 upto 200 Length
• All holders are black oxide and cotted with rust prevent.
• Rear thread for pull stud is M16 X 1.75.

Hindmechanisch's BT30 Morse Taper holder are used to hold Tang type shanks 

BT30 morse taper Is mainly used to hold Tang Type Drills and Arbors  

• Better shank taper - accurate, rigid toolholder-to-spindle mount
• Fully ground flange and V-groove, easy on the tool changers for less spindle and changer maintenance
• Made from alloy steel hardened to 54 – 56rc
• Balanced at G6.3 at 15,000 rpms by hammer machining machine.
• Concentricity is less than .005 micron upto 100 Length and 0.012 upto 200 Length
• All holders are black oxide and cotted with rust prevent.
• Rear thread for pull stud is M12 X 1.75.